SMB Beacon

The SMB Beacon uses named pipes to communicate through a parent Beacon. This peer-topeer communication works with Beacons on the same host. It also works across the network

Windows encapsulates named pipe communication within the SMB protocol. Hence, the name, SMB Beacon.

SMB Listener Setup

To create a SMB Beacon listener select Cobalt Strike -> Listeners on the main menu and press the Add button at the bottom of the Listeners tab display.

The SMB Beacon is compatible with most actions in Cobalt Strike that spawn a payload. The exception to this are the user-driven attacks that require explicit stagers.

Cobalt Strike post-exploitation and lateral movement actions that spawn a payload will attempt to assume control of (link) to the SMB Beacon payload for you. If you run the SMB Beacon manually, you will need to link to it from a parent Beacon.

The New Listener panel displays.

Select Beacon SMB as the Payload type and give the listener a Name. Make sure to give the new listener a memorable name as this name is how you will refer to this listener through Cobalt Strike’s commands and workflows.

Parameters

1) Pipename (C2)

• Set an explicit pipename or accept the default option.

2) Guardrails

• Beacon Guardrails allows the user to create a way to restrict the targets that the beacon can execute on.Once configured, these values will be the default guardrail for the Stageless or Windows Stageless Payload Generators.

• Press the ... button to open the Guardrails Settings:

1. IP Address: Enter a specific IP Address or generic wildcard of the right most segments. For example: l 123.123.123.123 l 123.123.123.* l 123.123.. l 123...*

2. User Name: Enter a specific name, or a value that: l “starts with”supported by “”wildcard character on the right side l “ends with”supported by “”wildcard character on the left side The guard is case-insensitive. Server Name: Enter a specific computer name, or a value that: l “starts with”supported by “”wildcard character on the right side l “ends with”supported by “”wildcard character on the left side The guard is case-insensitive

3. Domain: Enter a specific domain, or a value that: l “starts with”supported by “”wildcard character on the right side l “ends with”supported by “”wildcard character on the left side The guard is case-insensitive

Linking and Unlinking

From the Beacon console, use link [host] [pipe] to link the current Beacon to an SMB Beacon that is waiting for a connection. When the current Beacon checks in, its linked peers will check in too.

To blend in with normal traffic, linked Beacons use Windows named pipes to communicate. This traffic is encapsulated in the SMB protocol. There are a few caveats to this approach:

1) Hosts with an SMB Beacon must accept connections on port 445.

2) You may only link Beacons managed by the same Cobalt Strike instance.

If you get an error 5 (access denied) after you try to link to a Beacon: steal a domain user’s token or use make_token DOMAIN\user password to populate your current token with valid credentials for the target. Try to link to the Beacon again.

To destroy a Beacon link use unlink [ip address] [session PID] in the parent or child. The [session PID] argument is the process ID of the Beacon to unlink. This value is how you specify a specific Beacon to de-link when there are multiple children Beacons.

When you de-link an SMB Beacon, it does not exit and go away. Instead, it goes into a state where it waits for a connection from another Beacon. You may use the link command to resume control of the SMB Beacon from another Beacon in the future.